convertidor de medios PoE PSE Gigabit

Connect Gigabit-speed fiber optic to a 10-/100-/1000-Mbps copper UTP segment while also powering 802.3af devices at the end of the CAT5 run.

These PoE PSE Gigabit Media Converters enable you to transparently connect copper cabling to multimode fiber as an economical way to extend Ethernet communications well beyond the 100 meter CATx limit.

Along with matching copper to interference-free fiber at Gigabit speeds, the converter doubles as power sourcing equipment (PSE) for Power over Ethernet (PoE) devices plugged in on the copper side.

Using existing UTP cabling for both data communications and 48-VDC power simplifies a network application in terms of provisioning power and maintaining equipment. It’s particularly ideal for locating equipment where electrical access is inconvenient or just too expensive to locate. Install PoE-compatible security cameras and wireless access points in areas without any nearby power outlets while reducing your overall power consumption, too.

Plus, the PoE PSE Gigabit Media Converters have extensive power management features, including over current protection, undercurrent detection, minimum load sensing, and PSE MDI power enable/disable.

For reliable data communications, the media converter boasts link fault pass-through (LFP) capabilities, monitoring receive ports on both the fiber and copper sides for loss of signal. If signalling is lost on one media port, it automatically disables the transmit (TX) signal to the other media port.

Additionally, a far-end fault (FEF) function enables the converter to cease sending link pulse to a link partner if signalling on the fiber receive (RX) port is lost. The link partner will also synchronously stop sending data. This way, you don’t lose valuable data transmitted over an invalid link.

Standards — IEEE 802.3af (PoE), IEEE 802.3 (10BASE-T), IEEE 802.3u (100BASE-TX), IEEE 802.3z/ab (1000BASE-T), IEEE 802.3x full-duplex flow control, 1000BASE-SX

Distance (Maximum) —
UTP side: All: 100 m;
Fiber side (850nm MM):
LPS500A-MM-LC; LPS500A-MM-SC
62.5/125µm: 160MHz: 220 m; 200MHz: 275 m;
50/125µm: 400MHz: 500 m; 500MHz: 550 m
LPS500A-SM-10K-SC; LPS500A-SM-10K-LC
UTP side: 100 m;
Fiber side (1310-nm single-mode): 10 km

Connectors —
LPS500A-MM-LC; LPS500A-SM-10K-LC
UTP side: (1) RJ-45 (10BASE-T/100BASE-TX/1000BASE-TX);
Fiber side: (1) pair of LC
LPS500A-MM-SC; LPS500A-SM-10K-SC
UTP side: (1) RJ-45 (10BASE-T/100BASE-TX/1000BASE-TX);
Fiber side: (1) pair of SC

Power — Input: 100–240 VAC, 47–63 Hz; Consumption (maximum): 24 W

Size — 4.1H x 15.7W x 5.2D cm

Weight — 0.6 kg

Operating Temperature — 0 to 50°C